Multiple Choice
Identify the
choice that best completes the statement or answers the question.
|
|
|
1.
|
If damage is observed on the random orbit disk sander electrical cord what
should be done?
a. | Make sure it gets repaired before being used. | c. | Tape it up with electrical
tape. | b. | Purchase a new tool. | d. | Test the tool to see if it still operates, if so continue to use
it. |
|
|
|
2.
|
Which personal protective equipment should be worn by the operator when using
the random orbit disk sander?
a. | Safety glasses. | c. | Respirator or dust mask. | b. | Gloves. | d. | Both a and c. |
|
|
|
3.
|
A random orbit disk sander operator should _________________ before laying the
sander down.
a. | turn off the switch | c. | unplug the electrical cord | b. | turn off the
variable speed control | d. | make
sure the disk has stopped rotating |
|
|
|
4.
|
Just before turning the random orbit disk sander on the operator should
_______________.
a. | plug in the electrical cord. | c. | have a firm grip on the handle and
barrel. | b. | check the sandpaper to make sure it is properly attached. | d. | turn on the variable speed
control. |
|
|
|
5.
|
Which of the following conditions should be avoided when operating a random
orbit disk sander?
a. | Concrete Floors | c. | Outside operation | b. | Damp or wet areas | d. | Inside
Operation |
|
|
|
6.
|
Sandpaper must be installed evenly on the random orbit disk sander base pad to
prevent _______________.
a. | sandpaper from being thrown off. | c. | electrical
shock. | b. | premature tool wear. | d. | excessive sanding dust from being thrown off. |
|
|
|
7.
|
To get maximum life from sandpaper on a random orbit disk sander the operator
should _________________.
a. | hold the base pad flat on the material being sanded. | c. | reduce the variable speed control
rpm's. | b. | apply light sanding pressure. | d. | use only aluminum oxide sanding
disks. |
|
|
|
8.
|
How much pressure should be applied to the random orbit disk sander when
sanding?
a. | Heavy | c. | Medium | b. | None | d. | Light |
|
|
|
9.
|
The power cord should be placed ______________ when sanding with the random
orbit disk sander.
a. | around the operators neck | c. | away from the
work | b. | over the operators shoulder | d. | in front of the work so you can always see it. |
|
|
|
10.
|
When making adjustments to the random orbit disk sander which of the following
should be done?
a. | Turn off the circuit breaker. | c. | Hold the On/Off switch in the off
position. | b. | Have someone hold the tool while you make the adjustments. | d. | Unplug the random orbit disk
sander. |
|
Matching
|
|
|
a. | Base Pad | d. | Handle | b. | On/Off Switch | e. | Electrical Cord | c. | Variable Speed
Control | f. | Cord Strain
Reliever |
|
|
|
11.
|
#1
|
|
|
12.
|
#2
|
|
|
13.
|
#3
|
|
|
14.
|
#4
|
|
|
15.
|
#5
|
|
|
16.
|
#6
|